• Based on 8085 CPU operating at 6.144 MHz crystal frequency.
• 8/16K bytes of EPROM loaded with powerful monitor program.
• 8/16K bytes of RAM available to the user.
• Battery Backup for RAM with 3.6V rechargeable cell.
• Total on board memory expansion upto 64K bytes.
• Memory mapping definable by the user.
• Three nos. of 16 bit programmable TIMER/COUNTER using 8253.
• 48 programmable I/O lines provided through two nos. of 8255.
• RS-232C interface for CRT Terminal with auto baud rate.
• EPROM Programmer for 27 series EPROM with facility to Program, Verify, List & Blank Check.
• Two modes of commands: Hex Key pad mode & Serial mode
• All address, data & control lines are buffered and made available at 50 pin FRC connector as per STD bus configuration.
• 28 key hexadecimal keyboard and six seven segment display through 8279.
• Powerful software commands like Relocate, String, Fill, Insert, Delete, Block Move, Examine & Compare Memory, Examine Register, Insert Data, Delete Data, Single Step, Go, Break Point in both Serial and Keyboard mode.
• On board Single Line Assembler and Disassembler.
• Faclity for Downloading/Uploading files from/to PC.
• Power supply requirement: +5V/1.2A, +/-12V/250mA, +24V/21V/100mA
• User's Manual.
• Onboard 8 bit 8 channel ADC (Optional).
• Onboard 8 bit 1 channel DAC (Optional).

POWER SUPPLY - PS-III (Optional)

ORDERING GUIDE